NSCP 2015 · BUILDING PERMITS · PHILIPPINES
From loads to
permit-ready.
Enter your project once. BaseShear computes the NSCP seismic and wind analyses, load combinations, and every reinforced-concrete design sheet — then renders the complete structural analysis report your LGU expects. Days of Excel and Word, done in an afternoon.
THE WORKFLOW — THREE STEPS, IN SEQUENCE
Project data, once
Location auto-derives your seismic zone, fault distance, and wind speed — editable anytime. Loads come from NSCP table presets. Works fully offline on site.
Every NSCP check
Base shear, wind pressures, load combinations, and column, beam, slab, stair, and footing design — deterministic code equations with pass/fail on every sheet.
The report, permit-ready
Title blocks on every page, your PRC details throughout, STAAD figures placed where reviewers expect them. Re-export instantly after LGU comments.
WHAT BASESHEAR ACTUALLY DOES
Four things every signatory needs, computed correctly.
A guided flow, not a blank template
Project info, design criteria, member schedules, STAAD attachments — one validated sequence with NSCP-aware inline messages, so nothing is missing when a reviewer opens the report.
A code engine, not a spreadsheet
Deterministic NSCP 2015 formulas for seismic base shear, wind pressure, load combinations, and RC member design — golden-tested against known reference values, the same numbers every run.
Built for the site, not just the office
Entry, calculations, and preview run fully offline in the field. Edits queue and sync the moment you reconnect, with a clear offline chip and per-project sync status — never a lost session.
A report LGUs already recognize
Cover, section dividers, and a title-block footer on every page, engineer and PRC details throughout, STAAD figures placed where reviewers expect them. Re-export after every revision comment.
Design sheets reviewers recognize.
The output mirrors the report format LGUs already approve — because it was built from one.
RC COLUMN
P–M interaction · ties
RC BEAM
flexure · torsion · shear
TWO-WAY SLAB
coefficient method
RC STAIR
main + temp bars
ISOLATED FOOTING
bearing · punching
PRICING — GCASH · MAYA · GOTYME · BANK · PAYPAL
- 1 user · 3 report exports/month
- Extra export ₱99 credit
- All calculators, all sheets
- 1 user · unlimited exports
- Priority in the payment queue
- All calculators, all sheets
14-day full-access trial · no card required · activation within 12 hours of payment
Straight answers
Yes — the same way an LGU accepts a report built in Excel or STAAD. BaseShear performs the calculations; you, the licensed engineer, review every sheet, then sign and seal the report with your PRC number. Professional responsibility for the analysis stays with the PRC license holder, not with the software. The output format follows the reports LGUs already approve.
No — it replaces the days after STAAD. Upload your model figures and output; BaseShear computes the NSCP code checks (base shear, wind, load combinations, RC member design) and assembles everything into the formatted report.
GCash, Maya, GoTyme, bank transfer, or PayPal. Send the payment, upload your receipt with the reference code shown at checkout, and you're activated within 12 hours — usually much faster.
Nothing is deleted. Your projects stay visible and read-only; exports and edits pause until you renew. Approve a payment and full access resumes immediately.
Entry, calculations, and preview all run offline on your device. Everything queues and syncs the moment you reconnect — exporting the final PDF and payment actions need a connection.